Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterTrack Realignment in Lewisville, TX
When your garage door starts binding, making a grinding noise, or hanging up halfway through its cycle, you likely have a track misalignment issue. In Lewisville, TX, we see this often, especially in homes where the foundation shifts slightly during our hot, dry summers or after heavy spring rains. Realignment is a precision task, not a DIY weekend project. At Otto’s Garage Door, we handle track issues daily because a door that isn’t running straight puts massive, uneven stress on your cables and springs. If you need Garage Door Repair services in Lewisville, we’re here to help. If you notice your door hesitating or looking crooked as it moves, give us a call at (945) 777-4998. We provide upfront pricing, and I will be there myself to ensure the job is done right.
I have been serving Lewisville since 2004, and I have seen every type of track damage, from minor bumps caused by a stray bicycle in the garage to major shifts caused by settling foundations in neighborhoods like Castle Hills or around Lewisville Lake. Misaligned tracks are more than just an annoyance; they are a mechanical failure waiting to happen. If you suspect your tracks are the issue, you can read more about our full range of services on our Garage Door Repair in Lewisville page. We are locally owned and owner-operated, meaning the name on the van is the same name on the license, and I stand behind every repair with my 90-Day Done Right Promise.
When You Need Track Realignment
Your garage door system relies on perfectly parallel tracks to guide the rollers. Even a quarter-inch deviation can cause the door to bind or jump. You should call us if you notice any of these specific symptoms:
- The door stops and reverses: If your door hits a point where it suddenly stops or reverses while closing, it is often sensing resistance because the rollers are binding against a misaligned track.
- Grinding or scraping noises: A healthy door should be relatively quiet. If you hear metal-on-metal scraping, it usually means the door is rubbing against the track or the track is bent inward, digging into the roller path.
- Visible gaps between rollers and track: Take a look at your tracks when the door is closed. If you see rollers that are not sitting snugly in the center of the track, or if you see the door hanging crooked, the alignment is compromised.
- The door hangs up at a specific height: If your door consistently sticks at the same spot-perhaps three feet off the ground-that is a classic sign of a localized dent or a mounting bracket that has shifted loose.
- Loose mounting brackets: In older Lewisville homes, the lag bolts holding your tracks to the wall framing can work loose over time due to vibration. If the track wobbles when you push on it, it needs to be secured and realigned immediately.
If you see these signs, please do not try to force the door open or closed. A door that is 200 pounds riding on two springs is dangerous. If the tracks are bent, they can cause the cables to lose tension, which creates a serious safety hazard. Call us at (945) 777-4998, and I will get out there to inspect the system.
Our Track Realignment Process
When I arrive at your home, I don’t just hammer the track back into place. That is a temporary fix that will fail within weeks. We follow a systematic approach to ensure the tracks are structurally sound and perfectly level.
- Safety Inspection: Before touching the tracks, I secure the door and inspect the springs and cables. If the tracks are damaged because the door is failing elsewhere, I need to know that first.
- Bracket and Bolt Check: I check every mounting point. Often, the track itself is fine, but the lag bolts holding it to the wall have backed out. I tighten and, if necessary, replace these fasteners to ensure a solid foundation.
- Leveling the Tracks: Using a precision level, I verify that both the vertical and horizontal tracks are plumb and parallel. I adjust the brackets to ensure the door has a smooth, consistent path from floor to ceiling.
- Roller and Hinge Cleaning: Misalignment often happens because dirty or damaged rollers are dragging. I clean the tracks and check the rollers, replacing any that are chipped or worn, which is common with older Clopay or Amarr doors.
- Testing the Travel: Once the tracks are aligned, I run the door through its full cycle multiple times. I watch for any hesitation or noise. If it doesn’t run smooth, I keep adjusting until it does.
We are locally owned and owner-operated, so when I perform this process, I am doing it with the knowledge that I will likely see you again at the local hardware store. I don’t cut corners. If you need a home service provider who treats your garage door like my own, I am the one to call.
Track Realignment Pricing in Lewisville
I believe in upfront, honest pricing. I provide a quote over the phone that stays the same when I arrive at your driveway. We don’t use high-pressure sales tactics or hidden fees. Track realignment costs vary depending on the extent of the damage-whether it is a simple bracket adjustment or a full track replacement due to severe bending.
- Minor Adjustment & Tightening: $95-$145. This covers standard bolt tightening and minor bracket realignment.
- Major Track Realignment: $150-$250. This involves removing the tracks, re-leveling, and securing them to the framing, often required after foundation shifting.
- Track Replacement: Varies based on door weight and track gauge. We provide a firm quote before we start.
Remember, we offer a Free Second Opinion on any written estimate you have received from another company. We also offer a permanent 10% discount for seniors and veterans. If you have a repair over $200, we take $40 off the total. Call (945) 777-4998 to discuss your specific door issues, or search Garage Door Repair Near Me in Lewisville, TX-I answer the phone 24/7, even at nine at night.
FAQs - Track Realignment
Can I fix a bent garage door track myself?
I strongly advise against trying to bend a garage door track yourself. These tracks are under immense pressure, and if you accidentally release the cables or disrupt the spring tension, the door can fall or snap, leading to serious injury. A door is 200 pounds riding on two springs; respect the weight and the tension. Call us at (945) 777-4998 to have a professional handle it safely.
Is it cheaper to repair or replace the tracks?
If the damage is a minor dent or a loose bracket, repair is almost always the most cost-effective solution. However, if the track is kinked, twisted, or rusted through, it will never operate smoothly again, and replacement is the safer, smarter choice. I will be honest with you about whether a repair will last or if you are just throwing money away.
How long does track realignment take?
Most track alignment jobs take between one and two hours, depending on the complexity of the issue and the age of your door system. Because I am locally owned and owner-operated, I don’t have to wait for a dispatch center to clear my schedule. When I give you a time, I will be there.
Do you work on all garage door brands?
Yes, we are fully equipped to handle tracks for all major brands, including Genie, Clopay, Amarr, and Wayne Dalton. Whether you have a heavy wooden carriage-style door or a modern insulated steel door, the principles of track alignment remain the same. If your door isn’t running right, call us today for a free estimate.
Written by Otto Reinhardt, Owner at Otto’s Garage Door, serving Lewisville.